Angle unit: switching between DEG, RAD and GRA
A wrong trig result is usually a wrong angle unit. Fix it once in the fx-991EX SETUP menu and learn to read the status line.
5 min read Beginner updated 2026-11-05
When a trig result is off by a factor of 10 or 100, the calculation is usually fine and the angle unit is not. The fx-991EX shows the current unit on the top line of the display; check that marker before you change anything.
Read the current unit first
D on the top line means degrees, R means radians and G means gradians. If you are not sure, two quick checks settle it:
- In DEG, sin(30) should return 0.5.
- In RAD, sin(π÷6) should also return 0.5.
Input
sin 3 0 ) =
Result
0.5 (D on the top line)
A result of −0.9880316241 means the calculator is in RAD.
Switch to DEG, RAD or GRA
On the fx-991EX the angle unit is item 2 of the SETUP menu. You can change it at any time; there is no need to enter a calculation mode first.
Keystrokes
- 1 SHIFT MENU
Open SETUP. The gold label above MENU is SETUP.
- 2 2
Choose Angle Unit.
- 3 1
Choose Degree. Use 2 for Radian or 3 for Gradian.
- 4 AC
Leave SETUP. The D / R / G marker on the top line should change immediately.
Verify and avoid the common traps
Cross-check with two results
- 1 sin 3 0 ) =
In DEG this should return 0.5.
- 2 SHIFT MENU 2 2
Switch to Radian, then calculate sin(π÷6); it should still return 0.5.
- A mode change or reset can restore the default unit. Check D / R / G before starting a trig problem.
- Inverse trig results follow the current unit too. If you ask for 30° and get 0.5236, the calculator is still in RAD.
- If you see G, switch back to D. Gradians are rare in exams, but a stray G will skew the result just the same.
A fixed pre-exam check
Make “read D / R / G” part of reading the question: check the top line, then press sin, cos or tan. That habit is more reliable than hunting for SETUP during an exam.
Was this guide helpful?
Tell us what was unclear, missing or wrong. A concrete sentence is more useful than a rating.