Switch the angle unit (DEG / RAD / GRA)
Get the angle unit wrong and sin(30) comes out wrong. Here is the complete key path across four generations of key layout.
Applies to Casio ES / EX / CW and the TI-30 series · Updated 2026-11-01
The angle unit is a state marker on the screen, not a one-time setting: switching modes, resetting, or replacing the batteries can all send it back to the default. So before every trig problem, take a glance at the marker first - it is far cheaper than debugging afterward.
The keystrokes
The entry point differs a lot by generation: on the original ES it hides inside SETUP under SHIFT + MODE, EX moves it to SHIFT + MENU, and CW promotes SETTINGS to its own key. On TI there are two entry points: the DRG key (30 series) and the MODE menu (graphing models).
Verify
Switch to DEG and compute sin(30): you should get 0.5. Switch to RAD and compute sin(π/6): you should also get 0.5. Only when both hold has the unit really switched.
Keystrokes by series
Every group is checked against the layout data: if a key doesn't exist on that series, we don't draw it — we tell you which menu path to use instead.
ES PLUS Series
In the original ES SETUP you choose with the number keys or the arrow keys; press AC when done to exit, and the change takes effect immediately.
ClassWiz EX Series
On EX the SETUP opens with MENU; there is no MODE key anymore.
ClassWiz CW Full Function
CW gives settings their own key, so no leading SHIFT is needed.
TI-30X IIS
Each press of DRG cycles DEG → RAD → GRA, and the marker at the top of the screen changes with it.
TI-30XS MultiView
Pick the angle unit in the mode menu, then press enter to confirm.
TI-84 Plus
The second line of the MODE menu is Degree / Radian; pick one and press ENTER, then press 2ND + MODE to exit.