When two machines produce different results, the first reaction is that one of them must be broken. In practice, so long as the difference is stable and reproducible, it almost always comes down to one of the settings below. Genuine hardware faults show up as random flickering or dead keys, not as a consistent numerical gap.
Check in this order
| Symptom | The most likely cause | How to confirm it |
|---|---|---|
| A trig value off by an order of magnitude, or the wrong sign | Different angle unit (DEG / RAD / GRA) | Look for the D / R / G indicator at the top of the screen |
| Results with a fixed, short number of decimals | The display mode is set to Fix | Switch back to Norm and see whether the result gets longer |
| One gives a fraction, the other a decimal | Different output format settings | Convert between the two with S⇔D / FORMAT |
| The last few digits differ | Different significant-digit or rounding settings | Put both in Norm and compare again |
| A product off by a power of 10 | One side typed ×10^ by hand, the other used EE | Recalculate with both using the exponent key |
| Slightly different statistics results | One used σx and the other used sx | Check whether the denominator is n or n−1 |
The dangerous ones are the differences that raise no error
Angle unit, σx versus sx, and the Fix digit count give you no indicator of any kind. They simply hand you a different number, quietly. So when you check an answer, do not compare values alone; compare the settings under which each value was produced.
Only after the checks still leave a discrepancy should you consider the hardware: fit a fresh set of batteries, reset to the factory settings, and try the same problem again. A stable deviation that survives a reset is what actually warrants suspecting the machine.
Try it in the calculator
These links open the web tool. Where the article worked a specific example, the tool opens with that example already filled in, so you can check the claim instead of taking it on trust.